To activate Live GPS tracking in QGIS you need to select Settings ‣ Panels
GPS information. You will get a new docked window on the
left side of the canvas.
There are 4 possible screens in this GPS tracking window:
With a plugged in GPS receiver (has to be supported by your operating system) a simple click on [Connect] connects the GPS to QGIS. A second click (now on [Disconnect]) disconnects the GPS-receiver from your computer. For GNU/Linux gpsd support is integrated to support connection to most GPS receivers. Therefore you first have to configure gpsd properly to connect QGIS to it.
경고
If you want to record your position to the canvas you have to create a new vector layer first and switch it to editable status to be able to record your track.
If the GPS is receiving signals from satellites you will
see your position in latitude, longitude and altitude together with additional
attributes.
Figure GPS Position:
Here you can see the signal strenght of the satellites you
are receiving signals from.
Figure GPS Strength:
If you want to know where in the sky all the connected
satellites are, you have to switch to the polar screen. You can also see the
ID numbers of the satellites you are receiving signals from.
Figure GPS polar window:
In case of connection problems you can switch between:
A click on [Connect] again initiates the connection to the GPS receiver.
Figure GPS Tracking 2:
You can activate Automatically save added features
when you are in editing mode. Or you can can activate
Automatically add points to the map canvas with a certain width
and color.
Activating Cursor you can use a slider
to shrink
and grow the position cursor on the canvas.
Activating Map centering allows to decide in which
way the canvas will be updated. This includes ‘always’, ‘when leaving’ if your
recorded coordinates start either to move out of canvas or ‘never’ to keep map
extent.
Finally you can activate Log file and define a path
and a file where log messages about the gps tracking a logged.
If you want to set a feature manually you have to go back to
Position and click on [Add Point] or [Add track point].